Motorola 49901 - Vanguard 340 Router, Инструкция по эксплуатации

Страница: 86 / 121

3-28 Installation and Replacement
Modifying Your Vanguard 340 and 340 Enhanced
Note
The location of the FLASH SIMM and Data Compression (DCC/DSP)/
Encryption SIMM are indicated on the motherboard as shown in Figure 3-8.
Adding/Removing
SDRAM DIMM Use these steps to add and remove a SDRAM DIMM:
1) Insert the DIMM into slot U173 as shown in Figure 3-7.
2)
Carefully press the DIMM into the socket.
3) Lock the DIMM into place with the locking levers.
4)
To remove the DIMM, disengage the locking levers by pushing them forward,
and then lift out the DIMM.
Adding/Removing
FLASH SIMM Use these steps to add and remove a FLASH SIMM:
1) At a slight angle, insert the SIMM into connector U181 as shown in Figure 3-7.
2)
Carefully press the SIMM down, pushing the locking tabs through the holes. The
clips click into place.
3) To remove the SIMM, use your fingers to push back the two metal retaining clips
and lift out the SIMM.
Adding/Removing
Data Compression/
Encryption SIMM
To add and remove a Data Compression/Encryption SIMM on a Vanguard 340:
1)
At a slight angle, insert the SIMM into the J39 connector, lining up the holes
with the tab as shown in Figure 3-7.
2) Carefully press the SIMM down, pushing the locking tabs through the holes. The
clips click into place.
3)
Lock the SIMM into place with the locking levers.
4)
To remove the SIMM, use your fingers to push back the two metal retaining clips
and lift out the SIMM.