AGITO
AGITO User Manual OS 5.0 Nova
8 - System Overview
»
SYSTEM OVERVIEW: AGITO CORE
»
INTRODUCTION
The Core is the heart of your AGITO Modular Dolly System, within this module is contained all of the power management, RF /
Communications and Steering drivers.
»
DIMENSIONS
See “Technical Drawings” on page 66
»
KEY FEATURES
»
BATTERY POCKETS
ONLY MOTION IMPOSSIBLE APPROVED BATTERY PACKS SHOULD BE USED TO PREVENT
DAMAGE TO THE SYSTEM. ALWAYS OPERATE WITH 2 BATTERIES FITTED TO THE AGITO CORE,
THEY CAN BE HOT SWAPPED. ALWAYS USE BATTERIES OF THE SAME CHARGE LEVEL.
»
MAIN POWER SWITCH
Powers the CORE and attached accessories, the switch will illuminate when turned on.
Solid Red = Connected to MASTER Controller; Slow Flash = Searching for MASTER Controller; Fast Flash = System Error.
»
RF MODULE SLOT
See “RF Module & Communications settings” on page 50.
»
I/O PORTS
• 2x 12v DC Outputs – 4 Pin XLR connectors with a shared 2A load
• USB Connector – Not in Use (for future expansion).
• 2x AUX Ports – for connection to AGITO Accessories, including Tower, MAG-Sense and for Firmware updates
»
PAYLOAD MOUNTING RAIL
Payload mounting is provided via the 2 mounting rails on each side of the chassis. See “Attaching Camera Mounts” on page 35
I/O Panel
Main Power Switch
RF Slot
Steering Actuator
Mounting Rail
Drive-end Fixing Bolts
Battery Pocket