AGITO
AGITO User Manual OS 5.0 Nova
32 - Setting up
»
SPORTS DRIVE-END: WHEEL TRACKING
🌐
https://motion-impossible.com/how-to-videos/
Once the payload has been mounted to the system, it is advised to check the Wheel Tracking. If the
wheels are not straight to the chassis, then use the tracking adjustment bar to straighten the wheel.
Loosen the locking nuts at each end of the tracking trim rod
Rotate the rod until the wheels align.
Do this to all four wheels, remember to re-tighten the locking nuts.
ALWAYS ENSURE WHEELS AND TRACKING RODS ARE PROPERLY AND
SECURELY LOCKED AND FIXED TO THE AGITO DRIVE-ENDS.
»
SPORTS DRIVE-END: ADJUSTING SUSPENSION
🌐
https://motion-impossible.com/how-to-videos/
It is very important to adjust your suspension according to the system total weight. Incorrectly setup suspension
can cause handling problems and stability issues.
To adjust the suspension you twist the pre-load, moving it up or down depending on weight. Up for lighter
loads and down for heavier loads until the lower wishbones are horizontal, as shown below.
WHILE TWISTING THE PRE-LOAD MAKE SURE YOU DON’T UNSCREW
THE SHOCK CAP FROM THE MAIN SHOCK BODY.
TOO HIGH
CORRECT
TOO LOW
»
SPORTS DRIVE-END: ADJUSTING KICK-UP
🌐
https://motion-impossible.com/how-to-videos/
As standard the Drive-ends sit flat
Remove the four Kick-up adjustment screws and rotate the Drive-
end as required. Always ensure the screws are tight.
