6
Preparation for Use
•
Preparación para el uso
3
Fitting the Rear Axle Montar del eje trasero
5
Remove end caps. Position rear axle
assembly as shown. Brake levers
point towards you. Push both brackets
on until plastic tabs click into the slots
on the legs. Pull firmly on each
bracket to be sure the brackets are
securely attached.
Saque las cubiertas de los extremos.
Coloque el ensamble del eje posterior
como se demuestra, con las palancas
de freno apuntando hacia la parte de
atrás del coche. Tire firmemente cada
soporte para asegurarse de que se
estén bien colocados.
31
Safety Notes
8
Don’t let children play with or hang on to the pushchair.
Hold on to your pushchair when close to moving road vehicles or
trains. Even with the brake on, the draught from the vehicle may
move the pushchair.
If your pushchair is used by anyone unfamiliar with it, e.g.
grandparents, always show them how it works.
Never leave your child unattended, even for the shortest time.
BATTERY NOTES FOR TIME AND TEMP MONITOR
Non rechargeable batteries are not to be recharged.
Different types of batteries or new and used batteries are not to be
mixed.
Only batteries of the same or equivalent type as recommended are to
be used.
Batteries are to be connected with the correct polarity.
Exhausted batteries are to be removed from the product.
The supply terminals are not to be short-circuited.
TO REPLACE BATTERIES:
Remove 4 screws from the back of the unit. Back cover and front
cover assembly will separate from parent tray lid. Bend tab up slightly
and slide out old battery. Wait 5 minutes. Replace with type L1154 or
LR44. Reassemble.
NOTE: The Time and Temp Monitor should not be exposed to
extremes of temperatures or weather. At temperatures
below -20 C (-40F) or above 60C (140F) the display will turn off.
After the temperature returns to normal, press any button to
reactivate. Long term storage at temperatures exceeding these
can damage the Time and Temp Monitor.
