User Manual
rev.
1.1 of 16.12.2019
EN
Original manual
Fanmig J5 MOST
-8-
6. Fanmig J5 control panel
Figure 2: Fanmig J5 MOST Control Panel
6.1 Display
Shows parameter values, function symbols and units. Settings are made using the button (
2
)
and knob (
4
).
6.2 Additional function switch for MIG/MAG method (2):
When pressed, it switches between:
• welding parameters (voltage in volts and wire feed speed in m / min),
• arc length correction /
- 5 V from factory settings,
• IND Inducta
nce in the range of +/- 10 from factory settings,
• DIA Steel wire diameter: 0.8 mm or 1.0 mm to choose.
Parameter values are set with the knob (
4
), confirmed by pressing the knob. Having set the parameters,
the display automatically switches to the welding parameters in few seconds.
The button is not active in MMA and LiftTIG welding.
6.3 Selection of MIG / LiftTIG / STICK (MMA) welding method (3)
