User Manual
rev.
1.1 of 16.12.2019
EN
Original manual
Fanmig J5 MOST
-4-
The device has an IP21S protection rating for housing and may be exposed to atmospheric
fallout and is capable of operating outdoors.
- do not use the device for welding the tanks previously used for storing flammable substances.
ATTENTION
GASES AND FUMES
Using MIG / MAG, TIG and MMA techniques produces harmful gases and fumes containing
ozone and hydrogen as well as oxides or metal particles. Therefore, the welding work station
should be fitted with very good ventilation (dust and smoke extraction) or should be placed in
airy location. Metal surfaces intended for welding should be free from chemical contamination,
especially degreasers (solvents) that decompose during welding process and produce toxic
gases. Welding of galvanized, cadmium-coated or chromium-plated parts is permitted only
when a suction and filtering device is fitted, and with introduction of fresh air to the welding work
station.
RADIATION
Ultraviolet emission radiated when welding is harmful to eyesight and skin. Therefore a welding
mask with protective filters is required. Welding work station should meet certain requirements
and include:
• adequate lighting system,
• fixed or movable protection screens, governing bystanders against radiation
effects
(depending on requirements),
• placed in a room with appropriate wall colour (absorption of UV radiation)
FIRE PROTECTION
Welding work station should be located at a safe distance from flammable materials placed
especially on the floor or walls. All flammable materials need fire protection against hot metal
drops. It is recommended to fit the work station with fire blankets and fire extinguishers.
PROTECTION AGAINST ELECTRIC SHOCK
It is unacceptable
to connect the device to an improper installation or to an installation with
unverified zeroing efficiency. It is prohibited to use of device with shields removed or remove the
external shields while the device is connected to electric network. It is not allowed to work on a
suspended device (e.g. using a crane or a gantry). Only authorized persons should perform
maintenance and repair works keeping it in compliance with the safety conditions applicable to
renovation equipment.
2. Maintenance
ATTENTION
: In order to carry out any repair or maintenance activity, it is recommended to
contact your nearest technical support of
RYWAL-RHC
(a list of authorized service shops is
available on the last page of the manual).
In the event of noticing any damage, the welder should stop working, disconnect the device
from power supply and report it to direct supervisor or appropriate service
- technical support of
RYWAL-RHC
.
