User Manual
rev.
1.1 of 16.12.2019
EN
Original manual
Fanmig J5 MOST
-3-
Stop your work immediately after finding damage to the power cords. Do not
touch the damaged cords. Prior a repair or maintenance disconnect the device
from power source. Never use the device with damaged power cords.
Keep a fire extinguisher close to the welding location. After finishing welding
check work station against fire hazard.
Never try to fix a damaged gas reducer on your own. In case of malfunction
replace the reducer to a fully functional one.
Electromagnetic interference.
The device may influence other devices sensitive to electromagnetic interference
(robots, computers, etc.)
Always ensure that the devices within the welding work station are resistant to
interference.
In order to minimize interference it is recommended to use possibly shortest
welding cables arranged in parallel.
Always work in a distance at least 100 m from other sensitive devices. Always
make sure that the installation is grounded.
In case of interference with other devices, shield the cables or use appropriate
filters.
INTRODUCTION
Commissioning and normal operation are possible only after reading the carefully reading
following manual. Welding requires meeting the requirements for electric arc welding regulations
and complying with fire regulations. Device operator should be equipped with appropriate
personal protective equipment. It is necessary to use a set of personal protective equipment in
accordance with according to provisions of the Council Directive 89/686/EEC. Personal
protective equipment includes: welding mask, welding gloves, protective apron, leather shoes,
non-flammable welding clothing.
Despite the high technical standard of the device, the personnel should demonstrate
considerable discipline in terms of health and safety requirements that protect against harmful
and health hazardous factors resulting from welding technology.
OPERATING CONDITIONS
In order to ensure adequate service life and trouble-free operation:
- do not place or use this device on an inclined surface (of more than 15º),
- do not use the device for pipe defrosting,
- the device needs to be located in a place with free air circulation (with no restrictions of the air
flow to and from the fan). When connected to electrical network the device must not be
covered (for example, with paper or cloth),
- minimize the amount of dirt and dust that can get into the device,
