User Manual
rev.
1.1 of 16.12.2019
EN
Original manual
Fanmig J5 MOST
-13-
Figure 5: Fanmig device preparation for TIG welding.
8.4 Parameter settings for TIG welding
Select the LIFT TIG method with the button (
3
). Current is adjusted with knob (
4
). The welding
current in the TIG method is limited to 180A No other welding functions are available.
After opening the argon flow on torch handle, the arc is ignited by gently scratching the tungsten
electrode tip on the material and then raising it up by 2-3 mm: Welding ends with breaking the
arc in similar way to MMA welding and shutting off the gas flow.
9. MMA welding (coated electrode)
Connect the ground wire plug to the
7
(-) socket on the device
Connect the plug of the electrode holder to socket
6
(+) on the device. Some coated electrodes
require reverse polarity - see instructions on the electrode pack.
Figure 6: Preparation of Fanmig device for MMA welding (coated electrode).
