ZX Fire Alarm Control Panels
Page 42
Document No. 996-174-000-1, Revision: 01
Installation Manual
7 Appendix - ZX10Se Installation
7.1 General
The ZX10Se FACP has been designed to offer a solution to providing up to ten loops of fire
detectors without the need to install the panels in different locations on site. Two ZX5Se FACPs
are networked together within one large back box with provision for up to four 17Ah batteries to
be fitted. Depending on the configuration, the batteries either can be fitted inside the ZX10Se
backbox or, when a large capacity is required, these can be installed in adjacently-located
battery boxes (797-077).
The ZX10Se contains two PSUs and each must be provided with separate, mains supply wiring
from separate isolators.
7.2 Warnings and Cautions
Refer to Section 1.2 Warnings and Cautions before carrying out any procedures described in this
manual.
7.3 National
Approvals
Refer to Section 1.3 National Approvals for details of equipment compliance requirements.
7.4 Unpacking
Refer to 2 Unpacking for details of what equipment should have been supplied with the ZX10Se.
7.5 Installation
Refer to the procedure described in Section 3.1 Installing the Enclosure and Section 3.1.2
Mounting the Enclosure to the Wall for details of removing the internal equipment prior to
installing the ZX10Se enclosure.
Refer to Section 3.1.3 Remounting the Chassis for details of re-fitting the ZX5Se FACPs in the
enclosure.
