Morgana DIGIFOLD, Руководство по эксплуатации

Страница: 17 / 40

Operating the Digifold
Adjusting the Paper Gate
The standard setting for horizontal adjustment of the paper gate is 6.5mm (1/4") away
from the mounting block. Turn disc J to make this adjustment. This setting is only intended
as a guide, for instance, sheets with an upward curl will require this setting to be
increased. Set the height of the Paper Gate to approximately two thicknesses of paper, by
turning knob K. An excessive gap is a most likely cause of double sheet feeding.
J
K
6.5mm (1/4")
T W O T H ICK NE S S E S
OF P AP E R
W AR NING.
DO NOT ADJU S T T H E
P AP E R GAT E W H IL E T H E
MACHINE IS R U NNING OR
T HE S U CT ION DR U M MAY
B E COME DAMAGE D.
Se ting the suction slot
.
t
Setting the Adjustable Side Lay
The suction slot is located inside the vacuum roller and can be adjusted by releasing and
moving the suction knob horizontally in either direction to the required position.
For light stocks set the knob to the left and for heavier stocks set the knob to the right
Place the paper stack on to the loading table and slide up to the fixed side lay and paper
gate. Release the clamps located at each end of the side lay and slide up towards the
paper stack as shown in FIG 16.1. Allow a gap of approximately 0.5mm (1/64 inch) between
the paper and the side lay.
Adjustable
Side Lay
Page 17 SYSTEM
Digifold