Operating the Digifold
Storing Programs
Reading Stored Programs
Clearing Stored Programs
A maximum of 6 programs, of crease / fold settings, can be stored in the machine.
When the crease / fold settings have been correctly entered, the program can be
stored as follows:-
1.
Flick the Set Up switch down and then back up to its mid-position, the display
reads
2.
Turn the Setting Dial in either direction to cycle through the 6 memory addresses
available.
3.
To store a program to the displayed address, press the pushbutton PB4.
The display reads
‘StorE 1’
‘StorEd’
Hold down pushbutton PB4 and turn the Setting dial in either direction to cycle through
the memory addresses. When any one of the 6 addresses are displayed release PB4 to
view the stored program at that memory address.
A typical program will show
see page 14 for explanation.
To view or edit any of the creases or folds within the program, refer to steps 4. to 9. on
the ‘Set By Position’ instructions on pages 14 and 15.
Whilst viewing any of the stored programs, set the Set Up switch down and turn the
Setting Dial clockwise until the display reads
Press pushbutton PB4 to clear the stored program.
‘rESEt’.
3cF
100
Page 22
CREASING / FOLDING
Содержание DIGIFOLD
Страница 11: ...Page 11 SYSTEM Operating the Digifold Digifold ...
Страница 40: ...Page 40 CREASING FOLDING ...