Monosem NG Plus 2, Руководство оператора, Страница: 7 / 76

Operation
5
PLANTER PREPARATION
For the initial preparation of the planter,
lubricate the planter and row units as
outlined in the lubrication section of this
manual. Make sure all tires are properly
inflated, that all drive chains have the proper
tension, alignment and lubrication.
TRACTOR PREPARATION
Consult your dealer for information on the
minimum tractor horse power requirements
and tractor capability. Tractor requirements
will vary with planter options, tillage and
terrain.
One dual remote hydraulic outlet (SCV) is
required on models equipped with the
standard single valve hydraulic system. Two
dual remote hydraulic outlets (SCV) are
required on models equipped with the
optional dual valve hydraulic system.
PLANTER ATTACHMENT TO TRACTOR
Use the following six steps to attach your
planter to the tractor.
1.
Adjust the tractor drawbar so it is 13
to 17 inches above the ground. Adjust the
drawbar so that the hitch pin holes is directly
below the center line of the PTO shaft. Make
sure the drawbar is in a stationary position.
2. Back the tractor to the planter and
connect them with a hitch pin. Make sure the
hitch pin is secured with a locking pin or
cotter pin.
3.
Connect the PTO drive shaft to the
tractor. In addition to a standard 540 rpm
PTO, a 1000 rpm shaft is available.
CAUTION – Make sure that you
connect the proper end of the PTO to the
tractor. An arrow on the PTO indicates
the end of the constant velocity (double
clutch) that is attached to the tractor.
The following sticker is placed on your PTO
shaft for your safety...
DANGER – Rotating drive line
contact can cause death – keep away. Do
not operate without all driveline, tractor
and equipment shields in place ; without
drivelines securely attached at both ends,
and without driveline shields that turn
freely on driveline.
4.
Connect the hydraulic hoses to tractor
ports in a sequence which is both familiar
and comfortable to the operator.
DANGER – Before applying
pressure to the hydraulic system, make
sure all connections are tight and hoses
and fittings have not been damaged.
Hydraulic fluid escaping under pressure
can have sufficient force to penetrate
skin, causing injury or infection.
CAUTION – Always wipe hose ends
to remove any dirt before connecting
couplers to tractor parts.
http://hespareparts.com