Monosem NG Plus 2, Руководство оператора, Страница: 12 / 76

Operation
10
TRANSPORT TO FIELD OPERATION
Hydraulic Wing Fold
WARNING : Be sure the planter is
on a level surface, fore and aft and side to
side. Avoid standing between the wing
and main frame when folding the planter.
Wing may swing suddenly.
SUMMARIZED TRANSPORT TO FIELD SEQUENCE
. With center lift cylinders retracted and lock ups in place
remove wing lock pins.
. Move selector valve to "fold" position.
. Hydraulically fold wings out.
. Swing wing locking bolts into place.
. Extend lift cylinders.
. Remove center section lift cylinder lockups.
. Lower planter.
. Tighten wing locking bolts.
. Release turnbuckle at center of planter.
. Move selector valve to "marker" position.
NOTE : Read the following information for more detailed
instructions.
1.
If the wing lift tires are not retracted,
with the cylinder lockups in place on the four
center section lift cylinders, move the tractor
hydraulic lever to the lowering position until
the cylinders are fully retracted thus raising
the wing tires.
2.
With the planter raised and the
cylinder lockups in place, remove the wing
lock pins at the marker support and hitch.
3.
Position the selector handle on the
manual selector valve in the "fold" position.
4. Move the tractor hydraulic lever and
fold the wings out to operating position.
5.
Swing the wing locking bolts into
position to lock each wing.
6.
Operate the hydraulic lever to extend
all the lift cylinders.
7.
Remove the cylinder lockups from the
four center section lift cylinders and place
them in the storage position on the wheel
modules.
8.
Lower the planter.
9.
Using the special wrench which is
stored on the hitch of the planter, tighten the
¼" hex nuts to secure the wing locking bolts.
10.
Release the turnbuckle
located in the center of the planter frame ,
using the special wrench, and fold it to one
side . Return wrench to the storage position
on the longue.
11. Move the selector handle on
the manual selector valve to the "marker"
position. (Remove pressure from the
hydraulic system before moving the selector
handle).
http://hespareparts.com