Monosem NG Plus 2, Руководство оператора, Страница: 29 / 76

Lubrication
27
WHEEL BEARINGS
All wheel bearings should be repacked
annually and checked for wear. This applies
to all drive wheels, transport wheels and
marker hubs. To check for wear, lift the
wheel off the ground. Check for endplay in
the bearings by moving the tire in and out.
Rotate the tire to check for roughness in the
bearings. If bearings sound rough, the hub
should be removed and the bearings
inspected and replaced if necessary. See
“Wheel Bearing Lubrication or
Replacement”. To repack wheel hubs, follow
the procedure outlined for wheel bearing
replacement with the exception that bearings
and bearing cups are reused.
DANGER: Always install safety
lockups or lower to the ground before
working under or around the machine.
NOTE: Numbers on below illustration
correspond to photos on following pages
showing lubrication frequencies.
GREASE FITTINGS
Those parts equipped with grease fittings
should be lubricated at the frequency
indicated with an SAE multipurpose type
grease. Be sure to clean the fitting
thoroughly before using grease gun. The
frequency of lubrication recommended is
based on normal operating conditions.
Severe or unusual conditions may require
more frequent attention.
!
1
2
3
2 2 2
6 4
2 2 2 2
1
3
5
7 7
http://hespareparts.com