Monosem 7x7 NG Plus 4 Series, Руководство оператора и каталог запасных частей

Страница: 74 / 94

OPTIONS
PJ27078,0000046 -19-20MAR19-1/1
NG45009,00000BC -19-20MAR19-1/1
Setting Tank Pressure with Blower Eliminator
The central seed tanks must be pressurized to the correct
pressure settings for the system to work correctly. To
adjust tank pressure, adjust the hydraulic flow from the
tractor remote going to the hydraulic blower fan. Usually
this can be done from the tractor cab.
A hydraulic poppet valve is included in the system to cut
hydraulic flow to the blower when the planter is raised.
The valve is triggered by an implement lift switch. The
same switch will control the tank agitator motors, on or off.
An over-running valve is included in the hydraulic system
to prevent damage to the blower fan or hydraulics system
when the hydraulic flow to the blower fan hydraulic is shut
off.
Setting Tank Pressure with Blower Eliminator
The Blower Eliminator takes air from the vacuum fan and
directs it to the CSS tank to pressurize it. Follow these
steps to set the vacuum and tank pressure. Note: Be sure
the hydraulic system is warmed up before setting vacuum
and pressure levels. Settings will drop if set while oil is
below operating temperature.
1. With the Blast Gates (A) half open, lower the planter
to the plant position and start the vacuum fans. This
will activate the tank agitator. Ensure at least 20" of
vacuum to supply enough air to transfer seed to the
hoppers. Seed is needed in the meters so the plates
can be filled with seed. (Note: vacuum levels will be
higher when seed plates have seed on them).
2. Once enough seed has been transferred to the
hoppers raise the planter so the agitator stops.
3. Turn the seed shafts to fill the seed plates.
4. Set the vacuum to the desired level.
5. Adjust Blast Gates (A) to achieve desired tank
pressure.
APY09744
—UN—20MAR19
A—Blast Gates
6. Repeat Step 4 and Step 5 until desired setting are
achieved.
IMPORTANT: Make sure the case drain line for
the hydraulic fan motor is connected to a
zero-pressure drain port on the tractor.
Recommended Pressure Settings:
Corn and Cotton: 6-12osi (oz./sq. in.)
Soybeans: 6-12 osi
Milo and Rice: 6-10 osi
Edible Beans: 8-15 osi
Tank agitator should run with the planter lowered in the
field position. If lowered with tank full of seed for extended
periods of time, turn off tractor key or unplug agitator.
Microsem Microgranular Insecticide System
Standard Microsem System
The Microsem system meters microgranular products such
as insecticide and herbicide with precision. The system
is ground driven and has a positive displacement. The
output is set by means of a transmission that is unaffected
by a change in planting speed. The Microsem system is
mounted to the tool-bar frame with support brackets to
reduce weight on the planter unit. The Microsem system
with auger is equipped with a telescoping outlet, and its
output starts from a minimum of 2-3 lbs/acre.
Each Microsem hopper has a 33 lb. capacity and can be
used with a double outlet for two row units or with a single
outlet for one row unit.
The drive sprocket is mounted on the upper hex shaft.
The hoses direct the granular product directly between the
disc openers via drop tubes, or behind the disc openers
via a spreader tube.
60-13 061919