Monosem 7x7 NG Plus 4 Series, Руководство оператора и каталог запасных частей

Страница: 17 / 94

Safety
DX,PAINT -19-24JUL02-1/1
DX,TORCH -19-10DEC04-1/1
Remove Paint Before Welding or Heating
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated
by welding, soldering, or using a torch.
Remove paint before heating:
•
Remove paint a minimum of 100 mm (4 in.) from area
to be affected by heating. If paint cannot be removed,
wear an approved respirator before heating or welding.
•
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
•
If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or
paint stripper containers and other flammable material
from area. Allow fumes to disperse at least 15 minutes
before welding or heating.
Do not use a chlorinated solvent in areas where welding
will take place.
TS220
—UN—15APR13
Do all work in an area that is well ventilated to carry toxic
fumes and dust away.
Dispose of paint and solvent properly.
Avoid Heating Near Pressurized Fluid Lines
Flammable spray can be generated by heating near
pressurized fluid lines, resulting in severe burns to yourself
and bystanders. Do not heat by welding, soldering,
or using a torch near pressurized fluid lines or other
flammable materials. Pressurized lines can accidentally
burst when heat goes beyond the immediate flame area.
TS953
—UN—15MA
Y90
05-11 061919