Monogram Monogram ZIFS36N RH, Техническое обслуживание руководство

Страница: 17 / 62

– 15 –
Door Handle (Refrigerator and Freezer)
1. Open door to 90 degrees.
2. Remove 6 Phillips screws from the full-length
aluminum handle.
GEA00618
Door Gasket (Refrigerator and Freezer)
Note: The door gasket is held in a retainer
channel.
1. Pull the old gasket out of the channel.
2. Soak the new gasket in warm water to make it
more pliable.
3. Using the back of a teaspoon, push the barbed
edge of the gasket into the retaining channel.
Note: The inner door panel is foamed in place and
is available only as a complete assembly with the
exterior door panel.
Door Hinges (Refrigerator and Freezer)
Upper Door Hinge
Note: There is no adjustment for the upper hinge
assembly.
1. Remove the grille panel (see page 25).
2. Remove 3 Phillips screws and the vent guard.
3. Carefully pry the wire guard above the hinge
upward by inserting a flat head screwdriver
between the bottom edge of the wire guard and
the hinge.
Note: The plastic hinge cover is held by double-
sided adhesive tape.
4. Remove the hinge cover.
5. Remove T-20 Torx screws (3) securing the
upper hinge to the top of the cabinet.
6. Remove the hinge and bushing.
7. Remove T-20 Torx screws (4) and the hinge
from the door.
Door Closure Mechanism
The door closure mechanism uses a spring to
provide positive door closure from 30 degrees. The
door closure mechanism actuator arm has a
spring attached to the rear and is supported by
guide rollers on either side of the base channel.
The roller circumferences and the actuator arm
detents are matched for smooth operation. The
arm is attached to the door with an Allen head
shoulder bolt.
The plug in the wall receptacle is not accessible through the freezer machine compartment
because of the V-shaped condenser. To remove power from the freezer, disconnect the power
cord connector from the machine compartment electrical housing.