Money Controls TSP157, Техническое руководство

Страница: 12 / 45

Bulk Coin Recycler Technical Manual TSP157.doc Issue 1.3
– Jan 11

Money Controls 2008. All rights reserved.
Page 12 of 45
Pins 4 and 5, and pins 6 and 7, are linked internally. The provision of extra pins is to simplify
the manufacture of a multi-drop cable using thicker wire for the power leads. There can be a
‘power-in’ and a ‘power-out’ pin, and the hoppers daisy-chained.
Note: The hopper can only operate at 9600 baud.
2.10 Auxiliary Connector Type
Figure 3: SCH2 Auxiliary Connector
PCB Connector
2.54mm (0.1inch) pitch
Part No. : AMP 87631-2
2.10.1 AUXILIARY CONNECTOR PINOUT
Pin Function
1 High Level Plate
3 Low Level Plate
5 Plate Common
2 High Level Link
4 Low Level Link
6 Link Common
2.11 Operation
To notify the hopper software that level plate sensors are fitted, the link pins should be
connected as follows…
Mode Connections
High level plates only pin 2 to pin 4
Low level plates only pin 4 to pin 6
High & low level plates pin 2 to pin 4 to pin 6
Otherwise, no connections should be made.
The level plates themselves should be connected through the corresponding plate pin (pin 1
for high level, pin 3 for low level) and the plate common (pin 5).