Money Controls TSP157, Техническое руководство

Страница: 28 / 45

Bulk Coin Recycler Technical Manual TSP157.doc Issue 1.3
– Jan 11

Money Controls 2008. All rights reserved.
Page 28 of 45
3.11.2 DETAILS OF MATING CONNECTOR PLUG:
Supplier
– Harwin or equivalent:
Item 1 M22-3020500 5+5 DIL crimp housing
Item 2 M22-3050022 2mm crimp contact
Table 10: Flash Programming Interface
– Signal Details
Pin Signal Name Function
Input (I) /
Output(O) /
Power(P)
1 Tx D1 Transmit Flash data
– 5V TTL/CMOS
O
2 Gnd Connection to SR5i board ground (0V) P/O
3 Rx D1 Receive Flash data
– 5V TTL/CMOS
I
4 Vcc Connection to SR5i board +ve supply (+5V) P/O
5 SCLK Serial Clock
– active Low
I
6 CNVSS Programming voltage input
– link to pin 4
I
7 Key No connection. Used for polarising key No connection
8 BUSY Busy output
– no connection required
O
9 CE Chip Enable
– active Low
I
10 HOLD/EPM Hold/EPM
– active Low
I
3.11.3 PLUG WIRING DETAILS FOR FLASH PROGRAMMING SR5I PROCESSOR
Table 11: Flash Programming
– Connections Required
Pin Signal Connections for Flash Program mode
1 Tx D1 Transmit Flash data
– 5V TTL/CMOS
2,5,9,10 0V / Gnd External 0V / Ground connection
3 Rx D1 Receive Flash data
– 5V TTL/CMOS
4.6 Link on header plug
7,8 No connection
3 external connections are required for on-board flash programming.
Programming of the on-board processor flash memory requires a cable link to a separate
RS232 / 5V TTL/CMOS interface box connected to a PC COM port (COM1 or COM2).
Rotary switch must be set to Position 0.
Use Money Controls FlashProgrammer s/w utility to erase, download and verify the SR5i
flash memory.