Money Controls TSP157, Техническое руководство

Страница: 38 / 45

Bulk Coin Recycler Technical Manual TSP157.doc Issue 1.3
– Jan 11

Money Controls 2008. All rights reserved.
Page 38 of 45
Under NO circumstances should any solvent, abrasive or foam type cleaner be used.
Access to the coin rundown is gained by opening the reject gate.
3.17.3 ACCEPT GATE
Please refer to Figure 18 .
To detach the accept gate, first undo screw (9) and remove the rundown cover. Carefully
slide the gate spring (12) towards the rear of the SR5i and remove. Pull the gate forward and
downward to remove.
Re-fitting is the reverse of removal.
Take extreme care when re-fitting the accept gate spring.
3.17.4 SORTER
Please refer to Figure 18 .
Removal and Re-fitting.
Undo screw (9) and remove the rundown cover. The sorter can be unplugged and
withdrawn.
When re-assembling, ensure the sorter flaps are correctly fitted and not trapped.
3.17.5 REAR COVER
No User serviceable parts.
Access to all switches is achievable without removing the cover. Therefore the cover should
only be removed by approved service centres.
3.18 Fault Finding
The following information is presented for customers’ guidance in rectifying a fault but does not
cover all possible causes.
All acceptors with electronic faults should be returned to Money Controls Ltd. or to an approved
service centre for repair.
Symptom Investigate Possible Cause
Acceptor does not work
(all coins reject).
Connector.
Poor contact.
Loose wire.
Power supply.
Not switched on.
Incorrect voltage.
Inadequate current.
Rise time too slow.
Inhibit inputs. Acceptor inhibited.
Accept gate. Gate not free or dislocated.
Accept channel. Obstructed.
Reject gate. Not fully closed.
LED on rear cover is RED.
EEPROM checksum error
6
.
SR Sensor faulty
7,8
.
Credit sensor faulty
7,8
.
Credit sensor blocked
7
.
Sorter faulty
7,8
.
Sorter blocked
7
.
LED on rear cover is YELLOW.
Remove the power and re-apply. LED
should be green.