Mondolfo Ferro Aquila Alliance, Руководство оператора

Страница: 104 / 352

104
AQUILA ALLIANCE
User Manual
Move the bead-breaker disk at a distance of 2-3 mm from the rim edge.
Do not bring horizontally closer because when the upper arm comes closer so does
the lower arm.
NOTICE
Lower bead breaking (Fig.20)
- Preload the bead breaker disc using control (3, Fig.10a) (a tyre crushing preload of about 5
mm is advisable).
- Activate disc penetration (control 6 Fig.10a) and then start wheel spinning pedal control
(15 Fig.10), while lowering the bead breaker disc a little at a time (control 3 Fig.10a).
- Perform at least one complete spin to fully break the bead. The rim bead should be greased
during the spin.
- Set the upper arm downwards below the wheel
with (control 3 Fig.10).
6.6. DEMOUNTING
Positioning the tool (Fig.21).
- Move the column forward (pedal 13
Fig.10)
- Make the head (3 Fig.10) go down on the rim
(push-button 9 Fig.10)
- For correct tool positioning, the insert (G Fig.
21) must be at the end position with the rim
edge where the vertical wall begins.
- Press the block 9 Fig.21 to fix the tool (3
Fig.10) position.
Engaging the top bead (Fig.22)
G
9
23
21