PRIME TR3000
53
ENGLISH
Troubleshooting with error codes
The electronics are continuously running self-tests. If it fins any irregulatrities, the electronic console will display
an error code and stop normal operations for your safety.
Error codes:
E1 – Speed error
E6/E7 – Incline error
E1
When E1 is displayed, remove safety key and insert it again to restart treadmill. If E1 is still shown on
display, please check the following:
1.
Please check all cables connections is well connected.
2.
The treadmill did not move after pressing the ”START” button and show E1, please check if there
is any part stuck.
3.
The treadmill run for few seconds after pressing ”START” but stops, please check if the sensor
(near flywheel of front roller) is loose or defective
4.
Please check wires connected to the motor are tight and secure.
5.
Please contact your local distributor/place of purchase for technical service if E1 can not be
solved.
E6/E7 When E6/E7 is displayed, remove saftety key and insert it again to restart treadmill. If E6/E7 is still shown
on display, please check the following or call for service.
1.
Reset incline value:
(1) When the position of incline is lower than middle level, press the ”MODE” button and INCLINE
”^” button. Hold both buttons and the incline will be raised. Release the two buttons till the
incline position is up to middle level.
(2) When the position of incline is higher than middle level, press the ”MODE” utton and INCLINE
”V” button. Hold both buttons and the incline will be lowered. Release the two buttons till the
incline position is down to middle level.
Please try it for few times. If you can not get the incline moved, please contact local distributor/
place of purchase. Once the incline position is at middle level, please turn off power and restart.
Please see if E6/E7 goes away. If not, please contact your local distributor/place of purchase for
technial
service.
2.
Please check if red/white incline cables are well connected to MCB
3.
If the above steps can not reset incline, please contact your local distributor/place of purchase
for technical service.