Monaco SIGNATURE 2001 series, Руководство пользователя

Страница: 136 / 327

To Open the Main Awning:
• Insert the pull rod into the Z-Lock lever and pull down (fig.
1). This releases the awning.
• Insert the pull rod into the loop of the center control strap and
unroll the awning by pulling it toward you (fig. 2). Step under
the awning and roll or fold the control strap toward the back-
side of the roller and tuck it under the restraining strap.
• Release the rafter arm by pulling outward on the cap of the
ratchet stud. Raise the arm upward toward the case (fig. 4).
• Lock the rafter arm in position by pressing down on the steel
main arm bar (fig. 5) until the ratchet stud clicks. At this point
the fabric will be taut.
• Raise the awning to the desired height by releasing the snap
stud on the main arm and pushing up and out on the roller
assembly (fig. 6).
• Repeat steps 3-5 for the other end of the awning.
NOTE: Leave the Z-Lock open
when the awning is open to
avoid damage.
Partial Extension or
“CARAVAN” position:
• Insert the pull rod into the Z-
Lock lever and pull down (fig.
1). This releases the awning.
• Insert the pull rod in the loop of
the center control strap and
unroll the awning to the desired
extension.
• To prevent billowing, release and
raise the rafter arm (fig. 3) and
hook the claw of the arm into the
slot of the rafter lock (fig. 7).
This will require the awning to
be extended approximately four
and one half feet.
• Raise the awning to the desired
height by following step 5 from
above.
Equipment
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
S I G N A T U R E
5 • 1 3 6
AWNINGS