Molecular Devices SPECTRAmax 340PC, Руководство оператора

Страница: 56 / 69

Chapter 5
5-4 SPECTRAmax 340PC Microplate Spectrophotometer Operator’s Manual
number and contact Molecular Devices Technical Support or your local represen-
tative for assistance.
If the instrument is functioning normally when using SOFTmax PRO,
no errors should be in the buffer (except error number 100).
NOTE:
Table 5.1: Error Codes, Messages, and Notes about the Errors
Error
Code
Error Message Notes
100 command not found Command string was not recognized by the instrument.
101 invalid argument Command Argument does not match specified parameters or
syntax.
102 invalid data Command argument is out of acceptable range.
103 too many arguments Too many arguments after a specific command.
104 not enough arguments Not enough arguments for a given command.
105 input line too long Too many characters in the input line.
106 command error, system busy Instrument could not perform the given command because it was
busy doing another task. Example: Request a wavelength while
the monochromator is in motion.
107 command error, measure-
ment in progress Instrument could not perform the command because a measure-
ment was in progress.
108 command error, no data
available A request to the instrument to transfer data when there’s no data
in the buffer.
109 data buffer full Too many data sets in the buffer. Can be caused by setting up a
long kinetic run and disconnecting the computer or when
SOFTmax Pro is preempted by another application.
110 error buffer full More than 65 errors in the buffer.
205 user generated bus error Result of improper use of certain commands.
209 receive buffer overflow Caused by an external device sending too much data over the
serial port and ignoring flow control.
210 serial port parity error Parity bit error detected with incoming serial data.
211 serial port overrun error Caused by host computer sending too much data and ignoring
the flow control signal.
300 temp sensor faulty Unable to read a reasonable thermistor value. Thermistor is
faulty or disconnected, Main board problem, or ambient temper-
ature is out of range.