Molecular Devices MultiWash+, Руководство пользователя

Страница: 73 / 152

Chapter 6: Defining a Wash or Rinse Cycle
5032022 C 73
Select the Wash Mode for the Cycle
Select either the Bottom or Overflow wash mode for the cycle.
The Bottom wash mode places the needles on the manifold in the well to the position
defined for the microplate type. During the wash cycle, only the bottom of the well is
washed.
The
Overflow wash mode places the needles on the manifold above the well to the
position defined for the microplate type. During the wash cycle, the entire well is
washed. The wash solution is aspirated only after it reaches the aspiration needles on
the manifold.
When using the
Overflow wash mode, Molecular Devices recommends that you use a
dispense volume that is slightly more than the well volume.
For information on defining the Bottom and Overflow positions for a microplate, see
Defining a Microplate Type on page 77 .
Figure 6-8: The Wash Mode prompt
Button Action
On the left
Press this button to return to the previous step. See Select the Dispense Speed for
the Cycle on page 72 .
On the right
Press this button to end the process and return to Define Cycle without saving any
changes. See Defining a Wash or Rinse Cycle on page 65 .
Press this button to display either Bottom or Overflow wash mode.
Press this button to display either Bottom or Overflow wash mode.
Press this button to confirm the selection and then define the microplate shake time
for the cycle. See
Define the Microplate Shake Time for the Cycle on page 74 .
Table 6-8: Actions of Control Panel Buttons