Molecular Devices MultiWash+, Руководство пользователя

Страница: 111 / 152

Chapter 7: Defining a Microplate Type
5032022 C 111
Define the Overflow Dispense Height
The overflow dispense height defines the height of the manifold during a dispense for an
Overflow wash. The dispense height must be higher or equal to the height for aspiration.
When using the Overflow wash mode, Molecular Devices recommends that you use a
dispense volume that is slightly more than the well volume.
Figure 7-44: Overflow dispense height
You can define the overflow dispense height by editing the offset value, or by using the
"teach-in" method.
Figure 7-45: The Overflow Dispense Height prompt
Button Action
On the left
Press this button to end the process and return to Define Plate without saving any
changes. See Defining a Microplate Type on page 77 .
On the right
Press this button to move the microplate to the currently saved overflow dispense
position and switch to "teach-in" mode. See
Teach-In the Overflow Dispense Height
on page 112 .
Press this button to increase the offset value by 0.1 mm to a maximum of 18.8 mm.
Press this button to decrease the offset value by 0.1 mm to a minimum of 0.0 mm.
Press this button to accept the displayed offset value and then save the parameters
for the microplate type definition.
Table 7-33: Actions of Control Panel Buttons