Mold-Masters E-Drive Series, Руководство пользователя

Страница: 30 / 83

4.4.1 Status LEDs
1. Motor:
This LED turns on (green) when the servo(s) are enabled.
2. Alarm:
This LED will turn on (red) when an alarm is present. When it is off there
are no alarms present.
3. Heat :
This LED will turn on (green) when the ‘heats ready’ signal from the
external heat controller indicates that all zones are up to temperature.
The external heat controller may be integrated in the injections molding
machine or it may be standalone.
4. Auto :
This LED will turn on (green) when the system is in Auto mode. The
“System Ready” interlock to the molding machine will be turned on when
this led is on.
4.4.2 Control Buttons
NOTE
The control buttons are only active when on either tab of the Main Overview
Screen.
1. Jog/Tweak Open
In Manual mode pressing this button will move the pins toward the
opened position using the velocity and accelerate / decelerate values set
up using the “Section 6 - Plate Settings” on page 6-1.The pins will move
as long as the button is pressed.
In Auto mode pressing this button will incrementally move the pins by 0.01
mm in the open direction.
2.
Jog/Tweak Close
In Manual mode pressing this button will move the pins toward the close
position using the velocity and accelerate / decelerate values set on
“Section 6 - Plate Settings” on page 6-1. The pins will move as long as
the button is pressed.
In Auto mode pressing this button will incrementally move the pins by 0.01
mm in the close direction.
3. Step Mode
(Not in use - future functionality)
4. Manual Mode
Manual mode is the default mode.
To switch from Auto mode to Manual mode press this button and
acknowledge the confirmation message box that will appear on the touch
screen. The message banner will indicate the system is in Manual mode.
5. Auto Mode
Before the machine can be put into Auto mode, the servo(s) must be
enabled and no alarms present.
To switch from Manual mode to Auto mode press this button and
acknowledge the confirmation message box that will appear on the touch
screen. The message banner will indicate the system is in Auto mode.
6. Torque Monitor
Pressing this button opens the “Torque Monitor” window.
4-4
E-Drive Controller User Manual (with Pendant HMI)
OVERVIEW
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.