Mokon Duratherm, Инструкция по эксплуатации

Страница: 37 / 61

32
 Disconnect the electric power and the water supply to the system.
 Remove the back access panel to the system.
 Remove the heater bundle access plate.
 Disconnect the heater bundle wires.
 Remove the canister bolts.
 Pull the heater bundle away from the canister. The S.S. diverter is
inserted between the heater elements. Note the position of the
diverter relative to the elements; it must be inserted in the
same position for the new heater bundle.
 Clean the canister. Pay particular attention to the flanged area
where the gasket sits.
 Insert the diverter between the heater elements of the new heater
bundle as follows (see figure to the right):
o
Locate the "N" stamped on the lead end of the heater bundle.
o
Set the heater bundle upright on the lead end with the "N"
facing right (3 o'clock position).
o
Hold the diverter upright over the heater bundle with the gap
on the top and facing right (3 o'clock position).
o
Slip the diverter straight down between the heater elements
so that each section has an equal number of heater elements.
 Insert the new heater bundle into the canister with a new gasket so that the "N" stamped
on the lead end is in the 5 o'clock position.
(See figure below)
 Replace the canister bolts.
 Reconnect the heater bundle wires as diagramed on the back of the access plate.
 Replace the access plate.
GAP
HEATER ELEMENTS
LEAD
END