-38-
Revision 6/F3590
©
Moffat Ltd, February 2005
Figure 6.3.34
Figure 6.3.30
Four screws
Four
screws
6.3.24 INNER GLASS
1) Remove the outer glass (refer 6.3.23).
Uncrimp the retaining lugs of the window
spacer and remove the spacer and glass.
2) To replace, ensure the silicone rubber
seal has not been displaced. Clean the
glass and refit it. Place the window
spacer in position and crimp the retaining
lugs over to hold the glass in place. Refit
outer glass as above.
Retaining
lugs
Figure 6.3.31
5) Lift outer glass away from door.
6) To replace, ensure that the two silicone
rubber seals are in place on the left hand
and right hand side of the door frame.
Clean the inside of the glass and refit it,
ensuring that the silicone rubber seals
cover the outer edges of the glass. Refit
the trim panels.
Figure 6.3.33
6.3.25 DOOR SEALS
1) Open oven door.
2) To remove, hold at their centre point and
pull forward until they unclip
3) Refit new
seals.
NOTE:
Fit top and bottom seals first, with
open side of the seal facing
downwards. Fit side seals with open
side facing outwards.
6.3.26 DOOR PIVOT BUSHES
1) Remove door as per steps one and two of
section 6.3.23.
2) Remove the top and bottom pivot brackets
(two screws).
Door pivot
bush
3) Door bushes can now be removed and
replaced.
Two Screws
4) Reinstall door by reversing steps one to
two of section 6.3.23.
6.3.27 STAINLESS STEEL DOOR
- OUTER GLASS
1) Remove the door as per steps one and
two of section 6.3.23.
2) Remove the top and bottom pivots (two
screws each), and the door handle and
roller catches (two screws top and
bottom).
Door seals
Figure 6.3.32