Moffat turbofan E32SUBC, Руководство по обслуживанию

Страница: 48 / 68

6
Service Procedures
44
Revision 3
© Moffat Ltd, September 2009
E32SUBC OVEN and PROOFER
Figure 6.4.9a
6.4.9 Proofer Door Reversal
1) Whilst supporting door remove bottom hinge
body (two screws) and remove door.
Two Screws
2) Remove top hinge body (two screws).
3) Remove four cover screws covering alternate
hinge holes. Refit cover screws on opposite
side.
Figure 6.4.9b
4) Remove LH side panel.
5)
When changing to RH hinged door.
Remove LH magnet plate cover screws and
clips from inside LH wall (Do not fit cover
screws to old magnet position).
Transfer door magnet plate to opposite side.
When changing to LH hinged door.
Remove magnet plate and transfer to
opposite side.
Important: Redundant plate holes in LH side
wall must be filled to stop steam ingress into
wall cavity.
Figure 6.4.9c
Magnet plate
Magnet cover
screws
6) Fit bottom hinge body to top on opposite
side, centre hinge on slots.
7) Whilst holding door in place fit remaining
hinge body to bottom, securing door in
position.
8) Remove door handle (E89M only) (refer
6.3.10) and refit in the higher setting, using
the extra screw position.
9) Ensure door seal is removed and refitted with
join at bottom, centred over middle screw
head when closed.
10) Refit LH side panel.
6.4.6 Proofer Air Probe calibration
6.4.5 Oven Probe calibration
1) Place temperature probe in centre of oven.
2) Turn on oven and preheat.
3) Access Temperature offset screen (refer Op-
eration section P15)
4) Adjust display reading to measured reading.
1) Place temperature probe in centre of proofer.
2) Turn on proofer and preheat.
3) Access Temperature offset screen (refer Op-
eration section Pg15)
4) Adjust display reading to measured reading).
6.4.7 Proofer Water Heater Probe
calibration
1) Place temperature probe in water tank of
proofer.
2) Turn on proofer and preheat.
3) Access Temperature offset screen (refer Op-
eration section Pg15)
4) Adjust display reading to measured reading).
6.4.8 Proofer Water Float Switch
Adjustment
1) Adjust height of float switch
2) Refer Operation section P16 for display to
confirm operation.