Moffat turbofan E32SUBC, Руководство по обслуживанию

Страница: 45 / 68

6
Service Procedures
41
Revision 3
© Moffat Ltd, September 2009
E32SUBC OVEN and PROOFER
4) Remove two screws securing solenoid to
bracket, and withdraw solenoid.
5) Secure new solenoid with screws, and
re-assemble in reverse order.
6.3.15 Water Solenoid Cleaning
Figure 6.3.16
1) Disconnect water supply from the water
solenoid.
2) Remove the sieve from the water valve
assembly by pulling firmly away from the
assembly with a pair of pliers.
Sieve
3) Clean the sieve, removing all dirt and grime.
4) Replace the sieve and reconnect the water
supply.
Figure 6.3.16a
6.3.16 Float Switch
1) Remove Oven service panel (refer 6.1.2).
2) Remove float switch wires from relay, noting
their positions.
3) Remove brass fitting from rear of float switch.
4) Remove RH side rack and water trough from
inside proofer.
6.3.14 Water Solenoid
6.3.13 Autofill Relay
Figure 6.3.14
6.3.12 Door Pivot Bushes
1) Remove door as per steps one to three of
section 6.3.10.
2) Remove two screws (top and bottom) holding
hinge body to proofer.
3) Door pivot bush can now be removed and
replaced.
4) Re-assemble in reverse order.
1) Remove RH side panel (refer 6.1.2).
2) Pull relay from base.
3) Push new relay into base.
5) Replace RH side panel.
) Remove RH side panel (refer 6.1.2).
2) Remove wires from solenoid, noting their
positions.
3) Remove brass fitting from solenoid.
Figure 6.3.13
Relay