Modern Flames FusionFire 60, Инструкция по установке и эксплуатации

Страница: 6 / 22

P a g e | 6
2.2.2 Startup Using the Keypad Interface
Open the display panel by pushing down on the
small rectangle located in the lower right area of the
fireplace screen (see Figure 1). The display panel
will popup.
To the left of the display, press the power button on
the Settings Pad (Figure 2) and the “Initializing”
“Please Standby” display will appear while the
controller boots up and the steam supply is heated
(Approx. 3 minutes).
As soon as the fireplace is ready to operate, you will
see a “Ready” display. After a short delay, the
simulated fire will start and the display backlight will
turn off. The display may be pushed down again to
lock it into place, hiding it from view.
Note: The wireless remote control may also be used
to operate the fireplace.
2.2.3 Shutdown Using the Settings Pad
Press the power button again and the simulated
flame will shut off.
2.2.4 Operational Status Indicators
In Figure 2 there is an illustration of the fireplace’s
status indicators. The operational states are:
A – When the fireplace is first turned on and is
powering up, the “Initializing…” indicator will come
on, followed by the “Please Standby” indicator.
B – A timer shows how much time has elapsed since
the fireplace was first powered up. Typically, this
should not be more than a few minutes.
C – When the startup sequence is complete, the
“Ready!” indicator will appear and the unit is fully
operational.
D – When the water reservoir it low, the “Add Water”
indicator will come on to warn that more water
should be added for continued operation.
E – When it is necessary to replace the water filter,
the “Change Water Filter” indicator will come on.
F – If the fireplace’s viewing window (glass) is left
open or has not been closed properly, the “Viewing
Window Open” indicator warns that it should be
closed.
G – If the fireplace controller has detected a Fault
condition affecting proper operation, the “Contact
Service” and “Fault Code(s)” indicators will come on.
Please call a service technician to resolve these
types of problems.
H – The flame height, flame intensity and Aux. heat
settings are setup according to customer
preferences. These are confirmed by 3 rows of
indicators to view adjustments as they are entered.
Settings Pad – This entry pad allows for the power
to be turned on/off, the Aux. Heat to be turned on/off
and the operating menu to be accessed. The
fireplace settings may generally be changed by
scrolling through the menu and using the “-“ and “+”
adjustment buttons to make changes. If a Fault is
detected, the “Alert” indicator and corresponding
display will be activated.
Figure 1
Figure 2