English
20
Removal of door
The hinges (
A
) are equipped with two mobile staples (
B
) that clasped to the sections of the hinges
(
C
), when the door is completely open, block them.
The door is lifted towards the outside carrying out then the two movements described (
Fig. 6
); in order
to perform these actions hold the sides of the door close to the hinges.
To reassemble the door, insert the hinges in their specially devised slots.
Before closing the door remember to remove the two mobile staples (
B
) that were used to clasp the 2
hinges.
Oven lamp
Unscrew the protection cap (
A - Fig. 7
) protruding inside the oven and then reach the light bulb. After
having replaced the light bulb, re-assemble the protection cap (
A
).
Heating element
The resistor is removed by unscrewing, from inside the chamber, the screws that block it; the
electrical connections are accessible from behind once the back panel is removed.
Oven fan
Once the back panel of the oven is removed, from inside the oven, remove the pan support and the
fan protection. Unscrew the central nut, if needed also unscrew the lateral screwsfixig it on the crank
shaft, which sets the fan loose, Pull the fan out and unscrew the screws of the motor flange.
Gasket
Manually extract the gasket from its position and replace it with the new one without using tools.
