23
The Mounting Locations for the Spindle Unit
There are two locations (heights) for attaching the spindle unit.
Choose the correct location according to the cutting tool length and the thickness of the workpiece.
Spindle unit
Carriage
Approximately
20 mm (13/16 in.)
Approximately
80.6 mm (3-3/16 in.)
Spindle operating range
60.5 mm (2-3/8 in.)
Work plate surface
Spindle unit
Carriage
Spindle operating
range
60.5 mm
(2-3/8 in.)
Approximately
56 mm (2-3/16 in.)
Approximately
116.5 mm (4-9/16 in.)
Load the workpiece and install the tool. When using a base to load the workpiece, mount the base as well.
Make the layout the same as for actual cutting.
Move the spindle to its highest point. When viewed from the side, if the tip of the tool is lower than the surface of the workpiece,
remount the spindle unit at the higher location.
3
Make sure the tube is at the position shown in the
figure.
Insert the cord for the spindle unit into the jack.
2
Insert the cap screws at the locations shown in the
figure, and tighten them loosely using the included
hexagonal wrench (size : 3 mm). After attaching
all two screws in this way, tighten them securely.
Position the connector so the arrow
points to the back of the unit and
insert.
Tube
Make sure it is
at the base of
the cord.