Model Shipways Western Mountain Buckboard Wagon, Инструкция по эксплуатации

Страница: 7 / 36

Photo 2 Bottom view of completed platform with screw heads
Build Drilling Jig
Remove drill jig base 1” x 4” x 3/32” plywood from WB-3 plywood sheet 1.
Remove drill jig spacer 1/2” x 4” x 1/64” from WB-4 plywood sheet. 2.
Glue spacer to drill jig base and align along one edge and ends of base. 3.
Remove the small square from WB-1 1/16” sheet, sand edges then draw a reference line 4.
across the center line of the drill jig. This will aid in aligning the drill bit when drilling
through parts. (See Photo 3)
Build Wheel Fixture
Remove large square with hole in center from WB-3 the 3/32” plywood sheet. 1.
Locate 1/8” x 1/8” x 12” Basswood strip and cut eight (8) 1 inch pieces. 2.
Glue the 1” strips diagonally across each corner of on both sides square fixture. (See Photo 3.
25)
This wheel building fixture will also work as a flat working surface for seat spring assembly. 4.
(See Photo 5)
Platform Seat Spring Brackets – 2 needed.
Remove the two (2) platform spring brackets from WB-2 the 3/32” basswood sheet. 1.
On both, lightly draw a reference line 1/4” from front edge of bracket on the side of the 2.
part.
sing the drill jig carefully drill a hole on the center of the reference line with the flat edges 3.
of the brackets against the 1/64” spacer edge using a #55 drill bit held in a pin vise. Care
must be used to keep the drill bit flat on the jig surface and square using the reference line
drawn on the drill jig. (See Photo 3)