Model Shipways Western Mountain Buckboard Wagon, Инструкция по эксплуатации

Страница: 20 / 36

from the front and then glue two (2) square nuts to the bolt shafts. Note: Align the side of
the square nuts to be up and down (vertical). The king pin must fit between them.
Carefully form the center bolt pivot clip using the 1/32” brass rod 1/2” x 1/8” x 1/2” and dry 5.
fit to center of front axle and add the cast bolt pivot indexing over the pivot on the fifth
wheel. Glue both in place when satisfied with fit and add two (2) small square nuts. (See
Photo 18).
Photo 18
Rear Axle
Invert the platform assembly and rest parallel to work surface with the rear spring mount- 1.
ing surface facing up. Carefully apply glue to flat mounting surface of the painted metal
spring and set the wood axle cap flat mating surface in place and align the axle so that it
matches the metal surfaces.
Fit and glue the two (2) painted long rear axle clips that will hold the rear axle assembly
2.
to the rear spring; applying the clips down over the rear spring first. Then apply the painted
clip brackets and small square nuts. Allow the assembly glue to set.
Once the assembly glue is set, carefully adjust the axle/spring assembly to be parallel to 3.
the rear edge of the platform; both in looking down as well as from the rear views.(See
Photo 19)