Model Shipways Western Mountain Buckboard Wagon, Инструкция по эксплуатации

Страница: 29 / 36

to its final oval shape. All edges of the spokes from the oval cross section at the rim to the
rectangular cross section at the hub should be slightly rounded; no sharp edges only vary-
ing radii.
Photo 28
Stain the filed and sanded smoothed wheel and spokes making sure the upper part of the 19.
spoke adjacent to the wheel hub gets stained as well as the painted hub. The Dark Tan
paint works as a base coat color for the stain to match the spokes. You may have to use a
small brush to get into the tight areas. Wipe off excess stain and allow to dry completely.
Repeat Steps 18 & 19 for all wheels.
Using the 1/32” (#67) drill bit in a pin vise, drill holes through the rim centered between the 20.
spokes and down from the outside centered on the flat surface of the wheel rim where the
tire will be located. Note: Do not drill two locations directly opposite each other; these will
have the cast rim joining plates added in the center. (See Photo 29)