Model Shipways Western Mountain Buckboard Wagon, Инструкция по эксплуатации

Страница: 22 / 36

Add two (2) small square nuts to the 3/8” bolt shafts making sure to orient the side of the 9.
nuts vertically on either side of the king bolt round head.
Dry fit reach brace carefully to the reach arms (remove clamps holding arms to rear axle) 10.
and onto the king bolt (tape king bolt head to hold in place when alligator spring clamp is
removed) and reach arms aligning all the holes. The reach brace arms with pivot hole may
have to be carefully bent to align the hole onto the king bolt shaft. Once satisfied with dry
fit use spring clamp to hold in place and glue reach brace to reach arms. At the same time
add two (2) large square nuts to the shaft of the king bolt. NOTE: Add glue to only the top
large square nut to allow axle to turn freely. Let the glue joints set before next step. (see
Photo 20)
Once glue has set ream the rear reach plate and brace arm holes with #55 drill bit and 11.
insert/glue two (2) 3/8” painted round head bolts into rear holes and add two (2) small
square nuts onto bolt shafts.
Now ream the front holes and note: adjust and align the holes of the two small arms that 12.
come off the upper fifth wheel half to those in the reach arm. Add two (2) 3/8” painted
round head bolts down through the fifth wheel arms and add two (2) small square nuts and
glue in place. (See photo 20)
Photo 20
Move down to the holes in the center of the reach arms and align painted cross brace holes 13.
with holes in reach arm. Insert/glue two (2) 3/16” painted round head bolts into holes and
add two (2) small square nuts. Allow glue to set for cross brace joints. (See photo 21)
Reach to Rear Axle
Locate the two (2) painted rear axle clips with the longer bolt shafts and slip down over the 1.
rear axle and index into the two reach arm holes on each arm. Then carefully slip two (2)
painted clip brackets in place over the axle clip shafts. Slight tension should hold them in
place.