Mobotix M25 SERIES, Руководство пользователя

Страница: 79 / 128

79
/128
Network and Power Connection
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Connecting the Patch Cable to an MX-Overvoltage-Protection-Box, an MX-NPA-Box
or a Standard Network Outlet
To establish the network connection of the camera using an
MX-Overvoltage-Protection-Box or an MX-NPA-Box, remove
the blue bayonet catch and the blue sealing plug from the
right-hand side of the box. Insert the MOBOTIX patch cable
into the box and fasten the cable using the blue bayonet catch.
For additional‚ information on how to install an
MX-Overvoltage-Protection-Box
or an
MX-NPA-Box
, open
the Products > Accessories > Interface Boxes section on
www.mobotix.com
.
When using a standard network outlet (only for indoor installations), insert the MOBOTIX
patch cable of the M25 directly into the network outlet.
If additional cables are required inside the housing, they must be connected as described
in
Section 2.7.6, «Connecting a USB Cable» and Section 2.7.7, «Connecting a Two-Wire
MxBus Cable».
2.7.3 Power Supply Using a Switch
1. Connect the factory pre-installed cable of the camera to the
camera
connector of
the PoE adapter.
2. Connect the
LAN/Power
connector of the PoE adapter to the Ethernet connector
of the switch/router or the Ethernet port.
3. Plug the RJ45 connector of the power supply unit into the PC/Power connector
of the PoE adapter.
Patch cable
IP addresses in the
figure are shown
only as an example
For the M25 you should
use the blue MX-NPA-
PoE-Set or the MX-NPA-
Box – previous MOBOTIX
network power acces-
sories, such as the
NPA-Set, Power-Box and
Power-Rack (MX-NPA-
Set, MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the M25
Switch/router
PoE adapter
(MX-NPA-PoE)
Power supply
LAN/www
PC
(10.8.0.11/255.0.0.0)
Camera
(10.8.0.99)
LAN/Power
PC/Power
Camera
RJ45
RJ45
RJ45