MKS Baratron 740C, Руководство пользователя, Страница: 33 / 84

Chapter Two: Installation Interface Cables
23
Interface Cables
As of July 20, 2009, most products shipped to the European Community must comply with the
EMC Directive 2004/108/EC, which covers radio frequency emissions and immunity tests. In
addition, as of January 1, 1997, some products shipped to the European Community must also
comply with the Product Safety Directive 92/59/EC and Low Voltage Directive 73/23/EC, which
cover general safety practices for design and workmanship. MKS products that meet these
requirements are identified by application of the CE Mark.
To ensure compliance with EMC Directive 2004/108/EC, an overall metal braided shielded cable,
properly grounded at both ends, is required during use. No additional installation requirements
are necessary to ensure compliance with Directives 92/59/EC and 73/23/EC.
Note
1. An overall metal braided, shielded cable, properly grounded at both
ends, is required during use to meet CE specifications.
2. To order an overall metal braided shielded cable, add an “S” after the
cable type designation. For example, to order a 9-pin Type “D” cable
to connect a 740 transducer to a Type PDR-C-1 readout, use part
number CB700-2-XX, where XX designates the cable length; for a
braided, shielded cable use part number CB700S-2-XX.
Interface Cables
Transducer
Connector
MKS Power
Supply/Readout
Cable Description Cable Number
9-pin Type “D” Type 146, 660 9-pin Type “D” to 15-pin Type “D” CB700-1-XX,
CB700S-1-XX
PDR-C-1, PDR-C-2 9-pin Type “D” to flying leads CB700-2-XX,
CB700S-2-XX
Bendix Type 146, 660 Bendix to 15-pin Type “D” CB700-3-XX,
CB700S-3-XX
PDR-C-1, PDR-C-2 Bendix to flying leads CB700-4-XX,
CB700S-4-XX
15-pin High
Density Type “D” Type 146, 660 15-pin Type “D” to 15-pin Type
“D” CB700-5-XX,
CB700S-5-XX
PDR-C-1, PDR-C-2 15-pin Type “D” to flying leads CB700-6-XX,
CB700S-6-XX
where XX indicates the length of the cable, in feet
Table 6: Interface Cables