MK Products CobraTig 150 SM, Руководство пользователя

Страница: 20 / 29

CobraTig
®
150 Owner's Manual - Page 13
Print Graph
This function works with the Printer After Welds function. Pressing
this button toggles the command from YES (prints weld procedure
parameters plus
entire weld graph), to NO (prints weld procedure
parameters
only
).
Paper Feed
Press and hold this button down in order to feed paper through the
printer driver mechanism. This is especially useful after loading a new
roll of paper.
Printer Reset
Should the printer run out of paper either during a PRINT WELD or while
feeding, the PRINTER STATUS field will read as follows, “ERROR,
OUT
OF PAPER".
Once a new roll of paper has been loaded and fed through using the
PRINTER FEED button, press the PRINTER RESET button once. This
should return the PRINTER STATUS field to read, “OK”.
To load a new roll of paper, slide printer tray straight out until it
stops. Disengage the Printer Drive Mechanism by lifting up the
Drive Latch Arms on either side of the printer. Unroll approximately
4 to 6 inches of paper from the roll and feed through the slot,
pushing the paper through until it emerges from the front panel of
the printer tray.
Pull up any extra slack in the paper. Lower the Drive Latch Arms to
secure the Printer Drive Mechanism.
Press the PRINTER FEED button to align paper in Drive, then press
the PRINTER RESET button.
Active Program
Press this button in order to print the current weld procedure that is
loaded on the memory of the unit.
Last Orbital Weld
Press this button to obtain a printout of the last completed orbital weld.
This will give the same results as the PRINT WELD button on the WELD
ORBITAL screen.
Feed Paper Through Slot
Driver Latch
Arm
Driver Latch
Arm