Page 17
SECTION I INTRODUCTION
1-3. Pendant Control Unit
The hand-held pendant control unit (figure 1-3) has
a non-slip rubber cover which assures a positive
grip during use. A spring clip hanger is located on
the back of the control for storage. When the Pen-
dant Control is not in use, it should be stored on a
convenient side or end rail. A bracket is located un-
der the table top next to the pendant control con-
nector for storage of the Pendant Control when the
table is not in use and during cleaning. See figure
1-4.
POWER
INDICATOR
SIDE RAIL
CLIP
FUNCTION
BUTTONS
Figure 1-3. Pendant Control Unit
PENDANT CONTROL
STORAGE BRACKET
BACK
SECTION
SEAT
SECTION
Figure 1-4. Pendant Control Storage Bracket
The function push buttons are identified with abbre-
viated descriptions for all functions. See figure 1-5.
When illuminated the Trendelenburg and table up
buttons are red, the remaining buttons are all green.
AC100 -240 V POWER
ON INDICATOR LIGHT
(GREEN)
TRENDELENBURG
LATERAL TILT
RIGHT
BACK DOWN
TABLE DOWN
SLIDE FOOT
LEG DOWN
REFLEX
KIDNEY LIFT
DOWN
BRAKE UNLOCK
BEACH CHAIR
REVERSE
TRENDELENBURG
LATERAL TILT
LEFT
BACK UP
TABLE UP
(BRAKE LOCK)
SLIDE HEAD
LEG UP
FLEX
KIDNEY LIFT
UP
BATTERY
RETURN TO
LEVEL
Figure 1-5. Function Buttons
NOTE
If any buttons on the control unit are
pressed continuously for longer than 10
minutes, the thermal protector of the
pump motor will actuate and the opera-
tion of the table will be stopped. The
thermal protector will reset in approxi-
mately 30 minutes.
NOTE
The operating table a built-in
self-diagnosis function to check if the
operating table and control unit work
properly.
1. Connect the power cord.
2. Press the BATTERY ON/OFF button
on the pendant control.
3. Press one of the function buttons on
the pendant control.
If two green battery indicators are lit,
the pendant control works properly.
