Mitsubishi Fuso FK 2008, Руководство пользователя

Страница: 226 / 355

12-75
2 Replacing blade rubber only
1. Raise the wiper arm.
Pinch both sides (indicated by arrows) of blade
rubber with your fingers and then pull the
blade rubber so that claws are unhooked from
grooves in the blade rubber.
2. Slide out the blade rubber.
3. Replace the old blade rubber with a new genu-
ine wiper blade rubber.
To install, reverse the removal procedure. Make
sure that the claws fit into the grooves in blade
rubber.
1 Fluid level check
1. Open the front panel. P. 12-4
2. Check the amount of remaining washer fluid
using fluid level check hose .
3. If the fluid level has dropped to the lower part of
the hose or is not visible at all, add washer fluid.
2 Refilling
1. Open tank cap and add fluid until the level
nears the upper part of the hose.
2. Close the tank cap.
3. Close the front panel. P. 12-4
CAUTION
Substituting soapy water for washer fluid could
result in clogged washer nozzles or spots on
painted surfaces.
NOTE:
When it is very cold, the ratio of windshield washer
fluid to water should be increased in order to pre-
vent the mixture from freezing up.
Windshield washer – fluid level
check and refilling
Inspection
intervals
At the time of pre-operational
check and every 10,000 km
(6,000 miles)
Washer fluid tank
capacity
Approx. 5.5 liters
(5.8 qts)
Z09332
Z17352
FKFM.book Page 75 Wednesday, June 6, 2007 11:43 AM