Mitsubishi FREQROL-SFJ, Руководство по обслуживанию

Страница: 50 / 125

Parameter
Description
Setting range
(unit)
is switched.
Set when initialization (home
is required.
Otherwise, set
Standard setting: 0
39 Number of Number of gear teeth for gear 00' These
gear teeth is converted into hexadecimal
must be
(reduction value, and set.
set for orient
3A GRA2
ratio) on
Number of gear teeth for gear 01
spindle
spindle
is converted into hexadecimal
stop.
side
(driven
value, and set. 7FFF
3B GRA3 side)
Number of gear teeth for gear 10
is converted into hexadecimal
For NC display
value,
and set. its range is
3C GRA4
Number of gear teeth for gear 11
32767
is converted into hexadecimal
(decimal) and
value, and set.
conversion is
not required.
3D Number of
Number of gear teeth for gear 00
gear teeth (on motor side) is converted into When motor
(reduction hexadecimal value, and set.
speed is
3E GRB2
ratio) on
termined from
motor side
Number of gear teeth for gear 01
(drive
(on motor side) is converted into
the following
formula,
side)
hexadecimal value, and set.
3F GRB3
Number of gear teeth for gear 10
(on motor side) is converted into
should be set
hexadecimal value, and set.
with the
40 GRB4
Number of gear teeth for gear 11
mum integer
(on motor side) is converted into
ratio. (Note 1
hexadecimal value, and set.
N u m b e r o f
g e a r
m o t o r - s i d e
Motor
Parameters with mark are set on the NC side when
FR-SFJ
connected to M300 series CNC through bus line.
Note 1:
If value GRA or GRB is smaller than decimal
notation),
the same multiplier should be applied to GRA
and GRB to make the values larger than
Ex .: When
and GRB are 31 and 29 respectively, mul-
tiply these values by 4.
=
=
47