Mitsubishi MOTORS Mirage 2012, Руководство пользователя

Страница: 184 / 250

3. Rotate the jack by hand until the flange por-
tion (B) fits in the groove (C) at the top of
the jack.
4. Insert the bar (D) into the wheel nut wrench
(E). Then put the end of the bar into the
shaft’s jack end, as shown in the illustration.
Slowly rotate the wheel nut wrench until the
tyre is raised slightly off the ground surface.
WARNING
l Stop jacking up the vehicle as soon as the
tyre is raised off the ground. It is danger-
ous to raise the vehicle any higher.
l Do not get under your vehicle while using
the jack.
l Do not bump the raised vehicle or leave it
sitting on the jack for a long time. Both
are very dangerous.
l Do not use a jack except the one that
came with your vehicle.
l The jack should not be used for any pur-
pose other than to change a tyre.
l No one should be in your vehicle when us-
ing the jack.
l Do not start or run the engine while your
vehicle is on the jack.
l Do not turn the raised wheel. The tyres
still on the ground could turn and make
your vehicle fall off the jack.
5. Remove the wheel nuts with the wheel nut
wrench, then take the wheel off.
CAUTION
l Handle the wheel carefully when chang-
ing the tyre, to avoid scratching the wheel
surface.
6. Clean out any mud, etc. on the hub surface
(F), hub bolts (G) or in the installation holes
(H) in the wheel, and then mount the spare
tyre.
WARNING
l Mount the spare wheel with the valve
stem (I) facing outboard. If you cannot
see the valve stem (I), you have installed
the wheel backwards.
Operating the vehicle with the spare
wheel installed backwards can cause vehi-
cle damage and result in an accident.
7. Temporarily tighten the wheel nuts by hand
until the tapered parts of the wheel nuts
For emergencies
6-14
OA0X13E4
6