Mitsubishi Heavy Industries FDCW100VNX-A, Техническое руководство

Страница: 141 / 315

Control
‘19 • HM-T-340
Menu 1.3 - temperature scheduling
In the menu scheduling indoor climate (heating/cooling) is
scheduled for each weekday.
You can also schedule a longer period during a selected period
(vacation) in menu 4.7.
scheduling 1.3
cooling off
heating off
Menu 1.3.1 - heating
Increases or decreases in the accommodation temperature can
be scheduled here for up to three time periods per day. One
step is usually enough to change the room temperature by one
degree, but in some cases several steps may be required for the
accommodation temperature.
If a room sensor is installed and activated, the desired room
temperature (°C) is set during the time periods.
SCHEDULING HEATING 1.3.1
activated
schedule 2
system
schedule 3 schedule 1
all
mon
tues
wed
thur
fri
sat
sun
21:30 - 06:00 20.5°
Time period Adjusting Day
Activated Schedule System
Conflict
Schedule:
The schedule to be changed is selected here.
Activated:
Scheduling for the selected period is activated
here. Set times are not aff ected at deactivation.
System (RC-HY40
-W/HMA-S
only):
Which climate system the schedule is for is selected
here. This alternative is only displayed if more than one
climate system is present.
Day:
Select which day or days of the week the schedule is to
apply to here. To remove the scheduling for a particular
day, the time for that day must be reset by setting the start
time to the same as the stop time. If the line "all" is used, all
days in the period are set for these times.
The number of steps the value has to be changed to achieve a
degree change of the indoor temperature depends on the
heating installation. One step is usually enough but in some
cases several steps may be required.
The new value is shown on the right-hand side of the symbol
in the display.
CAUTION
An increase in the room temperature can be slowed by the
thermostats for the radiators or under floor heating.
Therefore, open the thermostats fully, except in those rooms
where a cooler temperature is required, e.g. bedrooms.
TIP
Wait 24 hours before making a new setting, so that the
room temperature has time to stabilise.
If it is cold outside temperature and the room temperature is
too low, increase the curve slope in menu 1.9.1.1 by one
increment.
If it is cold outside temperature and the room temperature is
too high, reduce the curve slope in menu 1.9.1.1 by one
increment.
If it is warm outside temperature and the room temperature
is too low, increase the value in menu 1.1.1 by one increment.
If it is warm outside temperature and the room temperature
is too high, reduce the value in menu 1.1.1 by one increment.
Control
- 139 -
#