Mitsubishi Electric PAC-USWHS002-WF-1, Руководство техника

Страница: 21 / 40

21
© 2021 Mitsubishi Electric US, Inc.
Specifications are subject to change without notice.
kumo station ®
The PAC-WHS01HC-E, Mitsubishi Electric Equipment Controller, kumo station contains relays that allow
for controls integration of third-party backup heaters, humidifiers, dehumidifiers, ventilation systems, and
hydronic heaters. kumo station may be optionally wired to an indoor unit. If you choose this configuration, set
up the indoor unit zone via kumo cloud before adding any kumo station accessories.
Note: Each kumo cloud Site can be associated with up to 1 kumo station. Multiple kumo stations can be
supported within an account by adding a separate Site for each kumo station.
Alternative Setup
Note: If attempting to set up a kumo station that is not directly connected to an indoor unit, follow these steps.
Refer to the Equipment Controller Manual (kumo station) for diagrams.
1. Remove kumo station cover.
2. Search for the SW1 switchboard. This is a very small group of switches in the middle of the device if
viewed vertically. This switchboard is labeled from #1-8.
3. Please switch the #5 toggle of SW1 to the "on" position, then press and hold the button nearest the
LEDs on the Wireless Interface for 5 seconds followed by quickly releasing it. Wait for the Wireless
Interface's blue LED lights to begin flashing quickly in groups of 4.
4. Once this state is reached, repeat the commissioning process for a kumo station that is not directly
connected to an indoor unit in order to connect Accessories (i.e. humidifiers,dehumidifiers etc.)
Note: For the system to function properly, the kumo station that is not connected to an indoor unit
must
be
the final wireless interface to be provisioned.
Add kumo station Accessory
Connect 22
Strong signal
For stronger signal, move
closer to the unit(s).
Home Program
4
Heater
Program Settings Home
NEXT
Channel 1
Cancel
Outside air temperature: None
How is the heater wired to
the kumo station®?
Channel 2
Channel 3
Channel 4
Wireless interface name
NEXT
Home
Accessory
Program
Settings
Home
Back
+
Add Wireless Sensor
+
Add Backup Heater
+
Add Humidifier
+
Add Dehumidifier
+
Add Ventilation
+
Add Hydronic Heater
Program Settings
Heater
1 new wireless interfaces
found. To which is the
heater wired?
In what location is ..BF:82:F5?
1
33
Third-party backup heaters, humidifiers, dehumidifiers, ventilation systems, and hydronic heaters can be
managed within kumo cloud by adding them as kumo station accessories. As many as 4 accessories can be
added to each kumo station.
To add a kumo station Accessory, first, install kumo station and accessories per PAC-WHS01HC-E Equipment
Controller (kumo station) installation manual (included with kumo station).
Then, from your kumo cloud app:
1. Tap
Add
(choose your preferred Accessory type).
2. Wait for the kumo station Accessory to be discovered.
Select
an accessory. If the kumo station
accessory is connected to an indoor unit, the zone name will be displayed. If the kumo station
accessory is not connected to an indoor unit, select the appropriate Wireless Interface from the list.
3. Provide a name to identify the kumo station accessory and tap
Next
.
4. Select the
Channel
to which the accessory is physically wired within kumo station. Tap
Next
.