Mitsubishi Electric PAC-USWHS002-WF-1, Руководство техника, Страница: 19 / 40

19
© 2021 Mitsubishi Electric US, Inc.
Specifications are subject to change without notice.
Add Wireless Sensor
Sensor
Settings Home Program
Back
Connect 75° 54%
For stronger signal, move
closer to the unit(s).
2
Very strong signal
1 new temperature/
humidity sensors found
Cancel Sensor
Settings Home Program
Back
Living room
To which wireless interface
should the sensor connect?
SAVE
Accessory
Settings Home Program
Back
+
Add Wireless Sensor
+
Add Backup Heater
+
Add Humidifier
+
Add Dehumidifier
+
Add Ventilation
+
Add Hydronic Heater
1
3
4
The PAC-USWHS003-TH-1 Mitsubishi Electric Wireless Temperature and Humidity Sensor is a wireless
sensor that is designed to provide remote sensing capabilities to the Wireless Interface. This is an optional
part . One Wireless Sensor may be configured for each Wireless Interface.
Note: We recommend that each sensor be commissioned to kumo cloud
®
BEFORE affixing to a wall or other
surface. This will ease set up.
1. Tap
Add Wireless Sensor
.
2. Wait for kumo cloud to locate your
Wireless Temperature and Humidity Sensor
device. View devices
located and tap the appropriate sensor to connect. Be sure the smartphone/tablet is within close
proximity to the sensor while searching. If the sensor cannot be located, try putting it into discovery
mode again and repeating the search. To put the Wireless Sensor into discovery mode, after the battery
insulation sleeve has been removed, knock on the sensor case or drop the sensor onto a table surface
from about 4" high until you hear the series of beeps or chirps.
3. Choose the
Zone
that the remote sensor should control (i.e. living room, kitchen, etc.).
4. Tap
Save
to continue back to advanced site settings.
To check Sensor battery life or battery replacement, refer to the Owner Manual at kumocloud.com under
Additional Resources.
Note: It is recommended that you commission the Wireless Sensor before adhering it to a wall.