7
2
3
3
1
left lower
right lower
Adjust the supports to
level the refrigerator.
adjustable
support
caster
Turn each
adjustable support
in the direction of
the arrow until
they touch the
floor to prevent
vibration and
noise and to keep
the doors level.
Strong belts
After adjusting the supports,
install the toe grille at the lowest
area on the front of the
refrigerator.
Adjusting tilted doors and
uneven refrigerator
If the installation area is not level or the
refrigerator supports sink after a few days due
to the weight of the food, the door will appear
lower. (Depending on the quantity of food, the
food weight can exceed 100 kg.) Readjust the
refrigerator by turning the adjustable supports
in the directions shown.
For example, if the refrigerator is installed in the
corner of a room, one of the rear supports may
sink into the floor. Use a caster stand (sold
separately) or strong plate at the rear of the
refrigerator. (In general, the plate should be 2–3
mm thick.)
To obtain a caster stand, contact your retail store.
Insufficiently adjusted supports can cause injury
due to movement of the refrigerator.
Caution
Turn the adjustable supports until
they touch the floor and the
casters are raised from the floor
to prevent vibration and noise, transmigration
and half-shut doors
Level the refrigerator left to right, with the
front of the refrigerator raised slightly, so that
the doors close easily and to prevent half-open
doors.
Prepare for earth-quakes
Thread strong belts through the 2 handy-grip recesses
on the top-rear of the refrigerator and secure them to
the wall, posts or other strong area
Consult the retail store at which purchase was made for tip-resistance belts for your
refrigerator (sold separately).
Your refrigerator tipping over can cause injury.
Warning
rear support
adjustable
support
right left
The refrigerator will not cool
immediately after power is turned on.
Do not damage the refrigerant circuit or the pipes nor
mount anything with screw.
Non-Freon Refrigerants are flammable gas. However, it is hermetically-
sealed, therefore, leaking is infrequent.
About Non-Freon Refrigerator
Please contact the retail store at which you purchased it or a Mitsubishi
Electric Maintenance Service or Customer Service representative.
Should the refrigerant circuit be damaged:
1. Do not use electric items or fire equipments near by.
2. Open the window and ventilate the room.
Warning
The control panel will display “H” for current
temperature (Numeric values will be displayed when
the temperature goes below 20˚C)
Initial is set to “Regular ice making mode”.
Especially during hot summers, ice may take 24 hours to make the first time, and
more than half a day may pass before the control panel displays numeric figures.
It will take 2-3 hours for the control panel to display numeric values.
(In particular, the vegetable compartment, which uses radiant cooling, can take
more than half a day to cool.)
Allow the refrigerator to cool sufficiently before you store non-cooled items and
ice cream. Open and close the doors only as much as necessary and do not leave
open for long periods of time.
To use the Crystal ice making mode, please change the setting for ice making
compartment.
page
11
Bef
ore Y
ou
Use Y
our
Refrig
erator
Содержание MR-S45N
Страница 30: ...MEMO ...
Страница 31: ...MEMO ...
