Mitsubishi Electric MELDAS MDS-R Series, Технические характеристики и инструкция по эксплуатации

Страница: 137 / 285

8. Setup
8 - 13
No. Abbrev. Parameter name Explanation
Setting
range (Unit)
In the case of the semi-closed loop control
Set the same value as SV020 (RNG2).
(Refer to the explanation of SV020.)
1 to 9999
(kp/rev)
In the case of the full-closed loop control
This is available for the relative position oblong wave output specification
linear scale.
Set the number of pulses per ball screw pitch.
Detector model
name
Resolution SV019 setting
Relative position oblong
wave output scale Refer to detector
specification manual. SV018 (PIT)(mm)/
Resolution (µm)
SV019 RNG1*
Position detector
resolution
1 to 9999
(kp/PIT)
Set the number of pulses per one revolution of the motor side detector.
Detector model name Motor type SV020 setting
OSA104S2 HF
□□
-A42 100
OSA17 HF
□□ -A47 100
SV020 RNG2*
Speed detector
resolution 1 to 9999
(kp/rev)
SV021 OLT
Overload detection
time constant Set the detection time constant of Overload 1 (Alarm 50).
Set to "60" as a standard. (For machine tool builder adjustment.) 1 to 999
(s)
SV022 OLL
Overload detection
level
Set the current detection level of Overload 1 (Alarm 50) in respect to the
stall (rated) current.
Set to "150" as a standard. (For machine tool builder adjustment.) 110 to 500
(Stall
current %)
Set the excessive error detection width when servo ON.
Rapid traverse rate (mm/min) <Standard
setting value>
OD1=OD2=
60×PGN1
/2 (mm) SV023 OD1
Excessive error
detection width
during servo ON
When "0" is set, the excessive error detection will not be performed.
0 to 32767
(mm)
SV024 INP
In-position
detection width
Set the in-position detection width.
Set the accuracy required for the machine.
The lower the setting is, the higher the positioning accuracy gets, however,
the cycle time (setting time) becomes longer. The standard setting is "50".
0 to 32767
(
µ
m)